Actron Elite AutoScanner® CP9185 - Manual (Page 41)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 3 – 7
Using The Scan Tool
3
AC Power Adapter
An AC power adapter (not included) can be used to power the Scan Tool
when reprogramming from a personal computer or for off-vehicle
reviewing of codes and printing.12V AC-DC converters are available at
most PC and electronic stores.
✓
The Scan Tool is equipped to accept any
110 VAC - 12 VDC wall adapter with the
following specifications:
❒ 500 mA minimum current unregulated wall power adapter
❒ 5.5 mm outside diameter
❒ 2.5 mm inside diameter
❒ The inside tip is positive (+)
Scan Tool Power UP
1. Connect Power Source
• Internal Battery (9V Battery), or vehicle Power DLC
• AC Adapter, or cigarette lighter cable.
2. Press and Hold ON/OFF key
• For 1 second until the Scan Tool turns on.
System Setup
✓
System Setup allows:
❒ Measurement units to be changed.
❒ Display contrast to be changed.
❒ Auto-Power off time to be changed.
❒ Scan Tool information to be viewed.
❒ Display to be checked.
❒ Operation of the keypad to be checked.
❒ Memory of the tool to be checked.
❒ Scan Tool to be upgraded, or programmed for a different
language.
12 V GND