Activeforever Invacare Pronto M41 Power Wheelchair with Semi Recline Seat - Manual (Page 68)

SECTION 14—ACCESSORIES
Pronto® M41 with SureStep® 68 Part No. 1143206
FIGURE 14.2 Installing/Removing the Oxygen Holder
Installing/Removing/Using the Walker Holder
ƽ INSTALLATION WARNINGS
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely.
The installation of the walker holder onto the back of the wheelchair seat increases
the length of the wheelchair up to nine inches. When turning the wheelchair it is
important to take note of this increased length - otherwise, injury and/or damage to
surrounding property may result.
NOTE: For this procedure, refer to FIGURE 14.3 on page 69.
Installing/Removing the Walker Holder
NOTE: Reverse this procedure to remove the walker holder.
NOTE: The Crutch/Cane Holder, Oxygen Holder, and Walker Holder all install into the accessory
tube. Only one of these may be installed at a time.
1. If necessary, loosen but do not remove the mounting knob.
2. Install the walker holder into the accessory tube.
3. Thread the mounting knob into the welded nut on the accessory tube. Securely tighten.
Clamp
Knob
Protective Caps
Welded Nut
Accessory
Tube
Mounting Nut
Mounting
Tube
Upper Support
Lower Support
Mounting Hand
Knob
Clamp
Knob
Welded
Nut
Mounting Bolt
Welded Nut
Protective
Caps
Clamp
Knob
Clamp
Knob
NOTE: Seat not shown.