Activeforever Invacare Pronto M41 Power Wheelchair with Semi Recline Seat - Manual (Page 17)

SECTION 3—INITIAL SETUP
Part No. 1143206 17 Pronto® M41 with SureStep®
SECTION 3—INITIAL SETUP
ƽ WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
Setup Checklist
NOTE: For this procedure, refer to FIGURE 3.1.
Follow the checklist below to ensure the wheelchair is properly setup before initial use.
❑ Place the wheelchair in a well
ventilated area where work can be
performed without risking damage to
carpeting or floor covering.
❑ Ensure the battery wiring harnesses are
properly connected to the right and left
batteries. Refer to Connecting/
Disconnecting Battery Wiring Harness
on page 63.
❑ Install the batteries into the wheelchair
base. Refer to Removing/Installing the
Batteries on page 61.
NOTE: Removing/Installing the Batteries
includes the following procedures:
• Disconnecting/Connecting the
Joystick
• Removing/Installing the Top
Shroud
• Removing/Installing the Seat
Assembly
• Removing/Installing the Joystick
Assembly
FIGURE 3.1 Setup Checklist
Shroud
Batteries
Wheelchair
Base
Seat