Activeforever Invacare Pronto M41 Power Wheelchair with Semi Recline Seat - Manual (Page 54)

SECTION 12—ELECTRONICS
Pronto® M41 with SureStep® 54 Part No. 1143206
SECTION 12—ELECTRONICS
ƽ WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
Removing/Installing the Joystick Assembly
NOTE: For this procedure, refer to FIGURE 12.1 on page 55.
Removing
1. Remove the tie‐wraps securing the joystick cable to the joystick mounting tube and
arm.
2. Turn the adjustment lock lever to release the joystick mounting tube from the
mounting bracket.
3. Remove the joystick assembly from the mounting bracket.
NOTE: The joystick mounting tube and joystick will remain connected to the wheelchair base by
the joystick cable. If necessary to remove the joystick assembly from the wheelchair base disconnect
the joystick cable the wheelchair base. Refer to Disconnecting/Connecting the Joystick on page 56.
Installing
NOTE: If necessary, connect the joystick cable to the wheelchair base before installing the joystick
assembly. Refer to Disconnecting/Connecting the Joystick on page 56.
1. Slide joystick mounting tube through the mounting bracket to the desired position.
2. Tighten the adjustment lock lever to secure the joystick mounting tube to the
mounting bracket on the other arm.
3. Using the tie‐wraps, secure the joystick cable to the arm (Detail “A”).