Adjusting footrest height – Activeforever Invacare Pronto M41 Power Wheelchair with Semi Recline Seat User Manual
Page 45
SECTION 10—FRONT RIGGINGS
Part No. 1143206
45
Removing
1. Push the front rigging release lever inward and rotate the footrest out.
2. Lift up on front rigging and remove from the wheelchair.
3. Repeat STEPS 1‐2 for opposite side of wheelchair.
Adjusting Footrest Height
Model PHWH93
NOTE: For this procedure, refer to FIGURE 10.2.
1. Remove any accessories from the footrest(s).
2. Remove the footrest from the wheelchair. Refer to Installing/Removing Front Riggings
NOTE: Lay footrest on a flat surface to simplify section.
3. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the
footrest support.
4. Reposition the lower footrest to the desired height.
5. Reinstall hex bolt, coved washers and locknut that secure lower footrest to footrest
support. Tighten securely.
6. Repeat STEPS 1‐5 for the opposite side of the wheelchair footrest, if necessary.
7. Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing Front
8. Reinstall any accessories onto the footrest(s).
FIGURE 10.2 Adjusting Footrest Height - Model PHWH93
Coved Washer
Hex Bolt
Footrest Support
Coved Washer
Locknut
Lower Footrest