Acnodes FES 5313 - Manual (Page 25)

Jumper Setting
DVI-I Port
The DVI-I port is used to connect an LCD monitor. This port supports DVI-D signal only. Connect the display device s
cable connector to the DVI-I port. After you plug the cable connector into the port, gently tighten the cable screws to
hold the connector in place.
BIOS Setting
Configure the display device in the Chipset menu ( North Bridge Configuration submenu) of the BIOS. Refer to
chapter 3 for more information.
RJ45 LAN Ports
BIOS Setting
Configure the onboard LAN in the Chipset menu ( South Bridge Configuration submenu) of the BIOS. Refer to chapter
3 for more information.
Driver Installation
Install the LAN drivers. Refer to chapter 4 for more information.
USB Ports
Pin Definition Pin Definition Pin Definition Pin Definition
1 VCC 2 VCC 3 -Data 4 -Data
5 +Data 6 +Data 7 GND 8 GND
9 Key 10 N.C
USB allows data exchange between your computer and a wide range of simultaneously accessible external Plug and
Play peripherals. The system board is equipped with four onboard USB 2.0/1.1 ports. The additional USB ports may be
mounted on a card-edge bracket. Install the card-edge bracket to an available slot at the rear of the system chassis and
then insert the USB port cables to a connector.
BIOS Setting
Configure the onboard USB in the advanced menu ( USB Configuration submenu) of the BIOS. Refer to chapter 3 for
more information.
Driver Installation
You may need to install the proper drivers in your operating system to use the USB device. Refer to your operating
system s manual or documentation for more information.