Acnodes FES 5313 - Manual (Page 2)

Copyright
This publication contains information that is protected by copyright. No part of it may be
reproduced in any form or by any means or used to make any transformation/adaptation without
the prior written permission from the copyright holders. The manufacturer reserves the right to
revise this publication and make changes to its contents at any time, without obligation to notify
any person or entity of such revisions or changes.
©2012. All Rights Reserved.
Trademarks
All trademarks and registered trademarks of products appearing in this manual are the properties
of their respective holders.
Notice:
1. The changes or modifications not expressly approved by the party responsible for compliance could void the user s
authority to operate the equipment.
2. Shielded interface cables must be used in order to comply with the emission limits.
Static Electricity Precautions
It is quite easy to inadvertently damage the system board, components or devices even before
installing them in your system unit. Static electrical discharge can damage computer components
without causing any signs of physical damage. You must take extra care in handling them to ensure
against electrostatic build up.
1. To prevent electrostatic build up, leave the system board in its anti-static bag until you are ready
to install it.
2. Wear an antistatic wrist strap.
3. Do all preparation work on a static-free surface.
4. Hold the device only by its edges. Be careful not to touch any of the components, contacts or
connections.
5. Avoid touching the pins or contacting all modules and connectors. Hold modules or connectors
by their ends.
Important:
Electrostatic discharge (ESD) can damage your processor, disk drive and other components. Perform the upgrade
instruction procedures described at an ESD workstation only. If such a station is not available, you can provide some
ESD protection by wearing an antistatic wrist strap and attaching it to a metal part of the system chassis. If a wrist
strap is unavailable, establish and maintain contact with the system chassis throughout any procedures requiring
ESD protection.