Acnodes FES 5313 - Manual (Page 24)

Jumper Setting
The VGA port is used for connecting a VGA monitor. Connect the monitor s 15-pin D-shel
port. After you plug the monitor s cable connector into the VGA port, gently tighten the ca
connector in place.
BIOS Setting
Configure VGA in the Chipset menu ( North Bridge Configuration submenu) of the BIOS.
information.
Wake-ON-PS/2 Keyboard/Mouse
The Wake-On-PS/2 Keyboard/Mouse function allows you to use the PS/2 keyboard or PS/2 mouse to power-on the
system. To use this function:
Jumper Setting
JP2 must be set to 2-3 On: +5V_standby . Refer to PS/2 Power Select in this chapter for more information.
BIOS Setting
Configure the PS/2 keyboard/mouse wake up function in the Advanced menu ( ACPI Power Management
Configuratio submenu) of the BIOS. Refer to chapter 3 for more information.
Important:
The +5V_standby power source of your power supply must support 720mA.
COM (Serial) Ports
COM 3 to COM 6 are fixed at RS232. The pin function of COM 1 and COM 2 ports will vary according to JP4/JP5 s
setting. Refer to COM1/COM2 RS232/RS422/RS485 Select in this chapter for more information. The serial ports are
asynchronous communication ports with 16C550A-compatible UARTs that can be used with modems, serial printers,
remote display terminals, and other serial devices.
BIOS Setting
Configure the serial ports in the advanced menu ( Super IO Configuratio
submenu) of the BIOS. Refer to chapter 3
for more information.
VGA Port
l cable connector to the VGA
ble screws to hold the
Refer to chapter 3 for more
Driver Installation
Install the graphics driver. Refer to chapter 4 for more information.