3Com 10014303 - Manual (Page 63)

Restore the SETUP message. undo isdn ignore llc
Configure the router to wait for CONNECT ACK message
replies from the connected exchange until switching to the
ACTIVE state. isdn waitconnectack
Configure the router to become ACTIVE to start data exchange
before receiving CONNECT ACK messages. undo isdn waitconnectack
The ISDN SETUP message contains the following information elements by default:
• High-layer Compatibility
• Low-Layer Compatibility
• Sending Complete
These can optionally be removed from the SETUP message.
6.3 Configuring the SPID Parameters of ISDN NI
Table 6-8 SPID Commands
Operation Command
On the BRI interface set the processing mode of the SPID to
NIT, i.e., non-initializing terminal mode.
isdn spid nit
Remove the NIT mode on BRI interface. undo isdn spid nit
Modify the time-interval of timer TSPID. isdn spid timer seconds
Restore the default value of the time-interval, undo isdn spid timer
Set the number of times to resend a message on the BRI
interface.
isdn spid resend times
Restore the default number of times to resend a message. undo isdn spid resend
Set the SPID value of channel B1. isdn spid1 spid
Delete the SPID value of channel B1. undo isdn spid1
Set the SPID value of channel B2. isdn spid2 spid
Delete the SPID value of channel B2. undo isdn spid2
Enable SPID negotiation on the BRI interface. isdn spid auto-trigger
Configure the service types that must be supported in SPI
negotiation on the BRI.
isdn spid service [audio | data | speech]
Delete the service types that are not supported in SPI
negotiation.
undo isdn spid service
By default, there is no NIT mode and no SPID 1 or SPID 2 value. SPID works in
AUTO mode. The time-interval for the TSPID Timer is 30 seconds. Information can
only be resent once.
3Com Router Configuration Guide Addendum for V1.20
63