3Com 10014303 - Manual (Page 58)

forwarding route
Delete the X.25-to-IP X2T
forwarding route
undo translate x25 x.121-address
2) Configuring an IP-to-X.25 X2T forwarding route
Perform the following configuration in system view.
Table 5-4 Configure an IP-to-X.25 X2T forwarding route
Operation Command
Configure an IP-to-X.25 X2T
forwarding route
translate ip ip-address port port-number x25 x.121-address
Delete the IP-to-X.25 X2T
forwarding route
undo translate ip ip-address port port-number
5.3 Displaying and Debugging the X2T Information
Execute the display and debugging commands in all views.
Table 5-5 Display and debug the X2T information
Operation Command
Display the static routing table of X2T display x25 x2t route
Display the dynamic routing table of X2T display x25 x2t switch-table
Enable X2T debugging debugging x25 x2t { all | event | packet }
5.4 Typical X2T Configuration Example
The configuration in this example interconnects an X.25 network and an IP network
Using a router, and allows the X.25 terminals and IP hosts to communicate by
applying the X2T technology to the router.
X.25 Terminal IP Host Router
E0 S0
IP Network X.25 Network
X.121 address
2222
X.121 address
1111
IP address
10.1.1.1
IP address
10.1.1.2
Figure 5-2 Networking for the X2T application
To configure X2T:
1 Enable X.25 switching
[3Com]x25 switching
3Com Router Configuration Guide Addendum for V1.20
58