3Com 10014303 User Manual

Page 57

Configure X2T route

I. Enabling X.25 Swit

hing

Before configuring X2T, you must enable X.25 switching.

Perform the following configuration in system view.

Table 5-1 Configure X.25 switching

Operation Command

Enable X.25 switching

x25 switching

Disable X.25 switching

undo x25 switching

5.2.2 Configuring the Interface at the X.25 Network Side

For information about the configuration of the interface at the X.25 network side, see

“Configure X.25” in Chapter 16 of the 3Com Router Configuration Guide.

You do not need to configure an X.121 address when configuring the interface at the

X.25 network side.

I. Configure the Interface at the IP Network Side

For the configuration of the interface at the IP network side, see the Network Protocol

section in the 3Com Router Configuration Guide.

II. Configuring an X.25 Route

Perform the following configuration in system view.

Table 5-2 Configure an X.25 route

Operation Command

Configure an X.25 route

x25 switch svc x.121-address interface serial number

Delete the X.25 route

undo x25 switch svc x.121-address [ interface serial number ]

III. Configuring an X2T Route

There are two types of X2T forwarding routes, one from IP network to X.25 network

and the other from IP network to X.25 network.

Configuring an X.25-to-IP X2T forwarding route

Perform the following configuration in system view.

Table 5-3 Configure an X.25-to-IP X2T forwarding route

Operation Command

Configure an X.25-to-IP X2T

translate x25 x.121-address ip ip-address port port-number

3Com Router Configuration Guide Addendum for V1.20