Xerox 4890 - Manual (Page 119)

SETTING THE SYSTEM CONFIGURATION
XEROX DOCUPRINT 4850/4890 IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM 4-63
3. On the Output DFA Profile window, specify the configuration
settings for the new output DFA profile.
Figure 4-50. Output DFA Profile window
You may make changes to the following fields:
•
Time Between Sheets (ms) (p1) — Specifies the time
required by the third party finishing device from the top of
the sheet to the bottom of the sheet. The printer inserts
skips to enforce this timing. You can specify from 0 to 32767
milliseconds.
• Time Between Sets (ms) (p3 or p3a) — Specifies the time
required by the third party finishing device from the top of
the last sheet in a set to the bottom of the first sheet in the
next set. The printer inserts skips to enforce this timing. You
can specify from 0 to 32767 milliseconds.