ZyXEL Communications P-2302HWUDL-P1 Series - Manual (Page 262)

Chapter 22 System
P-2302HWUDL-P1 Series User’s Guide
262
Figure 188 Maintenance > System > General
Each field is described in the following table.
22.2 Dynamic DNS Overview
Use this screen to set up the ZyXEL Device as a dynamic DNS client.
Table 112 Maintenance > System > General
LABEL DESCRIPTION
System Setup
System Name Enter your computer's "Computer Name". This is for identification purposes, but
some ISPs also check this field. This name can be up to 30 alphanumeric
characters long. Spaces are not allowed, but dashes “-” and underscores "_" are
accepted.
Domain Name Enter the domain name entry that is propagated to DHCP clients on the LAN. If
you leave this blank, the domain name obtained from the ISP is used. Use up to
38 alphanumeric characters. Spaces are not allowed, but dashes “-” and periods
"." are accepted.
Administrator
Inactivity Timer
Enter the number of minutes a management session can be left idle before the
session times out. After it times out, you have to log in again. A value of "0" means
a management session never times out, no matter how long it has been left idle.
This is not recommended. Long idle timeouts may have security risks. The default
is five minutes.
Password Setup
Old Password Enter the current password you use to access the ZyXEL Device.
New Password Enter the new password for the ZyXEL Device. You can use up to 30 characters.
As you type the password, the screen displays an asterisk (*) for each character
you type.
Retype to Confirm Type the new password again.
Apply Click this to save your changes and to apply them to the ZyXEL Device.
Cancel Click this to set every field in this screen to its last-saved value.