York YCAL0041 - Manual (Page 73)

YORK INTERNATIONAL 73
FORM 150.64-EG1
Typical Piping for Brazed-Plate
Coolers
Notes:
1. Placement on a level surface free of obstructions
(including snow, for winter operation) or air recircula-
tion ensures rated performance, reliable operation
and ease of maintenance.
2. Piping and wiring shown is for reference use only
and is not in accordance with any national or local
standards.
3. All wiring and piping must comply with applicable
local and national codes.
4. All wiring and piping must follow standard piping
techniques as discussed in the ASHRAE hand-
book.
5. A strainer with a mesh size between .5 and 1.5 mm
is recommended upstream of the heat exchanger to
prevent clogging.
Pressure
Gauge
INLET
OUTLET
Drain
Vibration
Eliminators
Vibration
Eliminators
Shut Off
Valves
Strainer
Vent
Flow
Switch
Isolation
Valves