Olympus VS120 User Manual
Page 37
33
Page
Proper Selection of the Power Supply Cord
If no power supply cord is provided, please select the proper power supply cord for the equipment by referring
to “Specifications” and “Certified Cord” below;
CAUTION: In case you use a non-approved power supply cord for Olympus products, Olympus can no
longer warrant the electrical safety of the equipment.
Specifications
Voltage Rating
Current Rating
Temperature Rating
Length
Fittings Configuration
125V AC(for 100-120V AC area) or , 250V AC (for 220-240V AC area)
10A minimum (for 100-120V AC area) or, 6A minimum (for 200-240V AC area)
60
C minimum
3.05 m maximum
Grounding type attachment plug cap. Opposite terminates in molded-on IEC
configuration appliance coupling.
Table 1 Certified Cord
A power supply cord should be certified by one of the agencies listed in table 1, or comprised of cordage
marked with an agency marking per Table 1 or marked per Table 2. The fittings are to be marked with at least
one of agencies listed in Table 1. In case you are unable to buy locally in your country the power supply cord
which is approved by one of the agencies mentioned in Table 1, please use replacements approved by any
other equivalent and authorized agencies in your country.
Country Agency Certification
Mark
Country Agency
Certification
Mark
Australia SAA
Italy IMQ
Austria ÖVE
Japan
JET, JQA, TUV,
UL-APEX/MITI
Belgium CEBEC
Netherlands KEMA
Canada CSA
Norway NEMKO
Denmark DEMKO
Spain AEE
Finland FEI
Sweden SEMKO
France UTE
Switzerland SEV
Germany VDE
United Kingdom
ASTA,BSI
Ireland NSAI
U.S.A UL