Olympus VS120 - Manual (Page 10)

Introduction
6 Page
Controller and software
Controller data may be destroyed and lost unexpectedly. Data acquired by the user should
be backed up regularly.
 Avoid connecting the controller directly to an external network (such as the Internet) to protect this system
against viruses and prevent the system against being updated unnecessarily. Otherwise the controller
may be corrupted due to severe viruses or other causes. If this system is infected with a virus, contact the
network-related personnel of your facility immediately.
 Our company will not take responsibility for any type of incidental damage, including damage to controller
data, caused by the use of this microscope system or the inability to use this microscope system.
 It is the user’s responsibility to create backups of data and maintain them in a safe place. (Our company
does not provide the service of supporting the user in creating backups of data or any other such service.)
 For information on matters related to controllers and Microsoft Windows 7, consult the manual provided
with your controller or operating software or the help function of the GUI
 Consult your local government for Windows Updates. Do not use Internet access for Windows Updates.
 Our company will not take responsibility for abnormal operation or malfunctions that may occur after the
controller environment settings (for example, BIOS settings) are changed or other software programs are
installed.
 If the free space on the data drive becomes low, the data processing speed will slow down noticeably or
errors may occur. It is recommended that you constantly delete unnecessary data files. The required
minimum free space is 120 GB.
 When the file fragmentation in the data drive progresses, the data processing speed may slow down
drastically or an error may occur. Be sure to check the properties of the data drive on regular base to
optimize it as needed.
 This microscope system does not support such power-saving modes as “standby mode” or “pause mode.”
Do not set such modes when using this microscope system.
 Never delete or change the names of the folders created by Olympus on the hard disk of the controller
being used upon the delivery of the microscope system. If they are deleted or their names are changed,
the software may no longer run.
 While the software of this microscope system is running, do not execute other software. If other software
is executed, there is a possibility that the software of this microscope system may not operate normally.