Xerox DC - Manual (Page 326)

Page 15 - 8 Xerox Document Centre Reference Guide
Paper
Handling
(cont’d)
Repeated Check Tray
Messages on the User
Interface and the paper is
loaded in the tray l Adjust the edge guides against the stack of
paper in the tray.
l If the edge guides were not set against the
paper stock in the tray when Start was
selected, delete the job in the job queue and
begin again.
Paper Curls l Load the paper in the paper trays seam side
of the paper up. Load the paper in the High
Capacity Feeder and Bypass Tray with the
seam side down.
l Load non-standard media in the Bypass
Tray.
l If the paper curls excessively, flip the paper
over in the applicable paper tray.
The Finisher does not stack
the output correctly l Unload the finisher tray frequently.
Depending on your machine configuration
there may be a pause button on the side of
the finisher.
l Do not remove stapled sets while the
finisher is compiling.
The Finisher does not
staple or staple well l The finisher does not staple stacks of more
than 50 sheets of 20 lb. paper.
l Use less than 50 sheets of paper if they are
heavier than 20 lb.
l Check the User Interface for a fault
message indicating no staples. Replace the
staple cartridge.
Problem Symptom Recommendation
The seam refers to the side of a
ream of paper with a split in the
wrapping. It may also be
referred to as arrow side first.