Log commands, Configuring what you want the zyxel device to log, Figure 174 displaying log categories example – ZyXEL Communications P-2602R-DxA Series User Manual
Page 312: Table 138 rfc-2408 isakmp payload types

P-2602R/RL-DxA Series User’s Guide
312
Appendix H Log Descriptions
The following table shows RFC-2408 ISAKMP payload types that the log displays. Please
refer to RFC 2408 for detailed information on each type.
Log Commands
Go to the command interpreter interface (
explains how to access and
use the commands).
Configuring What You Want the ZyXEL Device to Log
1 Use the
sys logs load
command to load the log setting buffer that allows you to
configure which logs the ZyXEL Device is to record.
2 Use
sys logs category
to view a list of the log categories.
Figure 174 Displaying Log Categories Example
3 Use
sys logs category
followed by a log category to display the parameters that are
available for the category.
Table 138 RFC-2408 ISAKMP Payload Types
LOG DISPLAY
PAYLOAD TYPE
SA
Security Association
PROP
Proposal
TRANS
Transform
KE
Key Exchange
ID
Identification
CER
Certificate
CER_REQ
Certificate Request
HASH
Hash
SIG
Signature
NONCE
Nonce
NOTFY
Notification
DEL
Delete
VID
Vendor ID
Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys exit ether wan
ip bridge lan
dsp voiceradius
ras>