ZyXEL Communications P-2602R-DxA Series - Manual (Page 247)

P-2602R/RL-DxA Series User’s Guide
Chapter 22 Tools 247
22.9.4 TFTP Upload Command Example
The following is an example TFTP command:
tftp [-i] host put firmware.bin ras
Where “i” specifies binary image transfer mode (use this mode when transferring binary files),
“host” is the device’s IP address, “put” transfers the file source on the computer (firmware.bin
– name of the firmware on the computer) to the file destination on the remote host (ras - name
of the firmware on the device).
Commands that you may see in GUI-based TFTP clients are listed earlier in this chapter.