ZyXEL Communications Prestige 642R Series - Manual (Page 85)

Prestige 642R Series ADSL Router
6-6 IPX Configuration
6.4.1 IPX Remote Node Setup
Follow the procedure in Chapter 5 to configure the protocol-independent parameters in Menu 11.1 –
Remote Node Profile. For the IPX-related parameters in Menu 11.3 – Remote Node Network Layer
Options, follow the instructions below.
To edit Menu 11.3 – Remote Node Network Layer Options shown in Figure 6-5, follow these steps:
Step 1. In Menu 11.1, make sure IPX is among the protocols in the Route field. (The Route field should
display Route= IPX, or IP + IPX.)
Step 2. Move the cursor to the Edit IP/IPX/Bridge field, then press the [space bar] to set the value to
Yes, and press [Enter] to open Menu 11.3 – Remote Node Network Layer Options.
Figure 6-5 Menu 11.3 - Remote Node Novell IPX Options
Menu 11.3 - Remote Node Network Layer Options
VPI/VCI (LLC-mux or PPP/PPPoE) Encap:
VPI #= 0
VCI #= 35
IP Options:
Rem IP Addr: N/A
Rem Subnet Mask= N/A
My WAN Addr= N/A
Single User Account= N/A
Metric= N/A
Private= N/A
RIP Direction= N/A
Version= N/A
Multicast= N/A
IP Policies= N/A IPX Options:
Rem LAN Net #= 00000000
My WAN Net #= 00000000
Hop Count= 1
Tick Count= 2
W/D Spoofing(min)= N/A
SAP/RIP Timeout(min)= N/A
Dial-On-Query= N/A
Bridge Options:
Dial-On-Broadcast= N/A
Ethernet Addr Timeout(min)= N/A
Enter here to CONFIRM or ESC to CANCEL: