ZyXEL Communications Prestige 642R Series - Manual (Page 146)

Prestige 642R Series ADSL Router
11-4 IP Policy Routing
MT Maximum Throughput
MR Maximum Reliability
MC Minimum Cost
Enter a number from 1 to 6 to display Menu 25.1.1 – IP Routing Policy (see the next figure). This menu
allows you to configure a policy rule.
Figure 11-3 IP Routing Policy
Table 11-2 IP Routing Policy
Field Description
Policy Set Name This is the name of the policy set assigned in Menu 25 - IP Routing
Policy Setup.
Active Press [SPACE BAR] to select Yes to activate the policy.
Criteria
IP Protocol IP layer 4 protocol, e.g., UDP, TCP, ICMP, etc.
Type of Service Prioritize incoming network traffic by choosing from [Don’t Care] / [Normal] /
[Min Delay] / [Max Thruput] / [Max Reliability].
Packet Length Enter the length of incoming packets (in bytes). The operators in the [Len
Comp] (next) apply to packets of this length.
Len Comp Press to choose from [Equal] / [Not Equal] / [Less] / [Greater] / [Less or Equal] /
Greater or Equal].
Menu 25.1.1 - IP Routing Policy
Policy Set Name= test
Active= Yes
Criteria:
IP Protocol = 6
Type of Service= Normal
Packet length= 40
Precedence = 0 Len Comp=
Source:
addr start= 1.1.1.1
end= 1.1.1.1
port start= 20 end= 20
Destination:
addr start= 2.2.2.2
end= 2.2.2.2
port start= 20 end= 20
Action= Matched
Gateway addr = 192.168.1.1
Log= No
Type of Service= Max Thruput
Precedence = 0
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.