ZyXEL Communications Prestige 642R Series - Manual (Page 67)

Prestige 642R Series ADSL Router
4-6 Remote Node Configuration
Figure 4-3 Menu 11.2 - Remote Node PPP Options
The following table describes the Remote Node PPP Options menu and contains instructions on how to
configure the PPP options fields.
Table 4-2 Remote Node PPP Options Menu Fields
FIELD DESCRIPTION OPTION
Standard
PPP
Encapsulation Select CISCO PPP only when this remote node is a
Cisco machine; otherwise, select Standard PPP.
CISCO PPP
Compression Turn on/off Stac Compression. The default for this
field is Off.
On or Off
(Default=Off)
Once you have completed filling in Menu 11.2 – Remote Node PPP Options, press [Enter] at the
message [Press ENTER to Confirm…] to save your configuration, or press [Esc] at any time to cancel.
4.1.5 Remote Node Filter
In Menu 11.1 – Remote Node Profile make sure the Edit Filter Sets field displays Yes by toggling the
[spacebar]. Press [ENTER] to access Menu 11.5 – Remote Node Filter.
Use Menu 11.5 – Remote Node Filter to specify the filter set(s) to apply to the incoming and outgoing
traffic between this remote node and the Prestige. You can specify up to 4 filter sets separated by commas,
eg. 1, 5, 9, 12 in each filter field. For more information on defining the filters, see the Filter Configuration
chapter. Note that there are two versions of this menu depending on whether you use PPPoE encapsulation
or not. When using PPPoE encapsulation, you can also specify remote nodes called filter sets.
Menu 11.2 - Remote Node PPP Options
Encapsulation= Standard PPP
Compression= No
ENTER here to Confirm or ESC to Cancel:
Press Space Bar to Toggle.