ZyXEL Communications Prestige 642R Series - Manual (Page 144)

Prestige 642R Series ADSL Router
11-2 IP Policy Routing
Figure 11-1 IP Routing Policy Setup
To setup a routing policy, follow the procedures below:
Step 1. Enter 25 in the Main Menu to open Menu 25 – IP Policy Routing Setup.
Step 2. Enter the index of the policy set you wish to configure to open Menu 25.1 - IP Policy Routing
Summary.
Menu 25.1 shows the summary of a policy set, including the criteria and the action of a single policy, and
whether a policy is active or not. Each policy contains two lines. The former part is the criteria of the
incoming packet, and the latter is the action. Between these two parts, the separator ‘|’ means the action is
taken on criteria matched and the separator ‘=’ means the action is taken on criteria not matched.
Menu 25 - IP Routing Policy Setup
Policy Policy
Set # Name Set # Name
------ ----------------- ------ -----------------
1 test 7 _______________
2 _______________ 8 _______________
3 _______________ 9 _______________
4 _______________ 10 _______________
5 _______________ 11 _______________
6 _______________ 12 _______________
Enter Policy Set Number to Configure= 0
Edit Name= N/A
Press ENTER to Confirm or ESC to Cancel: