ZyXEL Communications Prestige 642R Series - Manual (Page 49)

Prestige 642R Series ADSL Router
3-6 Internet Access
Figure 3-5 Menu 3.2.1 - IP Alias Setup
Follow the instructions in the following table to configure IP Alias parameters.
Table 3-1 IP Alias Setup Menu Fields
Field Description Example
IP Alias Choose Yes to configure the LAN network for the Prestige. Yes
IP Address Enter the IP address of your Prestige in dotted decimal notation 192.168.2.1
IP Subnet Mask Your Prestige will automatically calculate the subnet mask based
on the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the Prestige
255.255.255.0
RIP Direction Press the space bar to select the RIP direction from None, Both/In
Only/Out Only. None
Version Press the space bar to select the RIP version from RIP-1/RIP-
2B/RIP-2M. RIP-1
Incoming
Protocol Filters Enter the filter set(s) you wish to apply to the incoming traffic
between this node and the Prestige.
Outgoing
Protocol Filters Enter the filter set(s) you wish to apply to the outgoing traffic
between this node and the Prestige.
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm…] to
save your configuration, or press [ESC] at any time to cancel.
3.7 Route IP Setup
The first step is to enable the IP routing in Menu 1 - General Setup.
To edit Menu 1, enter 1 in the Main Menu to select General Setup and press [ENTER]. Set the Route IP
field to Yes by pressing the space bar.
Menu 3.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.