ZyXEL Communications Prestige 642R Series - Manual (Page 64)

Prestige 642R Series ADSL Router
Remote Node Configuration 4-3
Figure 4-2 Menu 11.1 - Remote Node Profile
Table 4-1 Remote Node Profile Menu Fields
FIELD DESCRIPTION OPTIONS
Rem Node Name This is a required field. Enter a descriptive name for the
remote node, for example, Corp. This field can be up to
eight characters. This name must be unique from any
other remote node name or remote dial-in user name.
Active Press [space bar] to toggle between Yes and No.
Inactive nodes are displayed with a minus sign (
– ) at the
beginning of the name in Menu 11.
Yes or No
Encapsulation PPP refers to RFC-2364 (PPP Encapsulation over ATM
Adaptation Layer 5). If RFC-1483 (Multiprotocol
Encapsulation over ATM Adaptation Layer 5) of ENET
ENCAP are selected, then the Rem Login, Rem
Password, My Login, My Password, Edit PPP
Options and Authen fields is not applicable (N/A).
Moreover, ENET ENCAP encapsulaton does not apply
for IPX routing. PPP
RFC-1483
ENET
ENCAP
Menu 11.1 - Remote Node Profile
Rem Node Name= ChangeMe
Active= Yes
Encapsulation= PPP
Multiplexing= LLC-based
Incoming:
Rem Login=
Rem Password= ********
Outgoing:
My Login=
My Password= ********
Authen= CHAP/PAP
Route= IP
Bridge= No
Edit PPP Options= No
Rem IP Addr= 0.0.0.0
Edit IP/IPX/Bridge= No
Session Options:
Edit Filter Sets= No
PPPoE Idle Timeout(sec)= N/A
PPPoE Service Name=
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
Enter a
unique name
of 8 or less
characters for
the Remote
Node Name.
Enter the IP
Address of
the Remote
Gateway
here.