Yamaha CLP-280 - Manual (Page 76)

76
CLP-280/270 Owner’s Manual
Detailed Settings
Detailed settings for the voices [VOICE SETTING]
In Dual mode, parameters with the “*” mark are set for Voice 1
and Voice 2 individually.
Parameter names enclosed in parentheses ( ) are displayed in
Dual mode.
The pitch of a note can be shifted upward or down-
ward in steps of an octave.
See the procedure on page 69.
In Dual mode:
Setting range:
–2 (two octaves lower) - 0 (no pitch shift) - +2 (two
octaves higher)
You can set the volume level for each voice part.
See the procedure on page 69.
In Dual mode:
Setting range:
0 - 127
You can specify the position in the stereo image
from which you hear the sound.
See the procedure on page 69.
In Dual mode:
Setting range:
L64 (hard left) - C (center) - R63 (hard right)
The pitch of the two sounds selected in Dual mode
can be “skewed” slightly away from each other.
See the procedure on page 69.
Setting range:
–20 - +20 (Positive (+) settings will raise the pitch of the
first sound and lower the pitch of the second sound.
Negative (–) settings will do the opposite.)
Setting the octave [Octave]*
Setting the volume level [Volume]*
TIP
TIP
B
D
NO YES
A
C
Main Set?-->
Octave 0
B
D
NO YES
A
C
MainxLayer Set?-->
Octave(GrndPno1) 0
Voice for editing (Voice 1 or Voice 2)
B
D
NO YES
A
C
Main Set?-->
Volume 100
B
D
NO YES
A
C
MainxLayer Set?-->
Volume(GrndPno1) 100
Voice for editing (Voice 1 or Voice 2)
Setting the position of right and left
channels [Pan]*
Make fine adjustments to the pitch
(only in Dual mode) [Detune]
B
D
NO YES
A
C
Main Set?-->
Pan C
B
D
NO YES
A
C
MainxLayer Set?-->
Pan(GrndPno1) C
Voice for editing (Voice 1 or Voice 2)
B
D
NO YES
A
C
MainxLayer Set?-->
Detune + 3