Yamaha CLP-280 User Manual
Page 113
CLP-280/270 Owner’s Manual
113
Appendix
CLP-280/270: Keyboard Stand Assembly
9.
Set the adjuster.
Rotate the adjuster until it comes in firm con-
tact with the floor surface.
10.
Attach the headphone hanger.
You can attach a headphone hanger on the
Clavinova to hang the headphones.
Install the headphone hanger using included
two screws (4 x 10mm) as shown in the figure.
Voltage Selector
Before connecting the AC power cord, check the setting
of the voltage selector which is provided in some areas. To
set the selector for 110V, 127V, 220V or 240V main volt-
ages, use a “minus” screwdriver to rotate the selector dial
so that the correct voltage for your region appears next to
the pointer on the panel. The voltage selector is set at
240V when the unit is initially shipped.
After the proper voltage has been selected, connect the
AC power cord to the [AC INLET] and an AC wall outlet.
A plug adaptor may be also provided in some areas to
match the pin configuration of the AC wall outlets in
your area.
WARNING
An improper voltage setting can cause serious damage to
the Clavinova or result in improper operation.
After completing the assembly, please check the
following.
• Are there any parts left over?
Review the assembly procedure and correct any errors.
• Is the Clavinova clear of doors and other movable fix-
tures?
Move the Clavinova to an appropriate location.
• Does the Clavinova make a rattling noise when you
shake it?
Tighten all screws.
• Does the pedal box rattle or give way when you step
on the pedals?
Turn the adjuster so that it is set firmly against the
floor.
• Is the power cord inserted securely into the socket?
Check the connection.
• If the main unit creaks or is otherwise unsteady when
you play on the keyboard, refer to the assembly dia-
grams and retighten all screws.
After transporting the instrument, do the following to
ensure optimum performance of the iAFC function
(page 81):
• Place the Clavinova so that its rear panel is at least 10 cm
away from the wall.
• Perform the automatic adjustment of the iAFC function
CAUTION
When moving the instrument after assembly, always
hold instrument by the lower surface in the front of the
main unit and by the handles in the rear panel.
Do not hold the key cover. Improper handling can
result in damage to the instrument or personal injury.
Do not hold here.
Hold here.