Yamaha CLP-280 - Manual (Page 111)

CLP-280/270 Owner’s Manual
111
Appendix
CLP-280/270: Keyboard Stand Assembly
3-3
Align the dimple on side A with the inner side
of E and F. Simultaneously lower the left and
right side of A, and secure with E and F.
3-4
Support the backside of E and F with your
hand, and slightly push A in from the keyboard
side until it stops.
3-5
Remove the side panel protection pad.
4.
Attach A.
4-1
Secure A using two 6 x 16mm short screws
from the rear.
4-2
Secure A using four 6 x 16mm short screws
from the front.
4-3
Firmly tighten the screws you temporarily
secured in step 2-4 above (assembly B).
Tighten these in order starting with the top side
first, then the bottom. Make sure as you do this that
the spaces on the left and right sides (indicated by
1 and 2 below) are even.
CAUTION
Fingers can become pinched between the main unit and
the rear or side panels, be extra careful so as not to drop
the main unit.
CAUTION
Do not hold the keyboard in any position other than the
position shown in the illustration.
Place your hands
at least 10 cm from either
end of A when positioning it.
4-2
4-3