ZyXEL Communications AES-100 - Manual (Page 43)

AES-100 User’s Guide
ADSL Configuration 5-11
5.5.21 Set PVC Command
Syntax:
192.168.1.1 adsl> set pvc [
vpi> ]
where
= port number, from 1 to 8.
= either “llc” or “vc"
= the VPI setting of the ADSL port for use with a TX based network
= the VCI setting for the ADSL port for use with a TX based network
= the VPI setting for the ADSL port for use with Rx based networks
= the VCI setting for the ADSL port for use with Rx based networks
The and settings will be equal to those of and if the rx settings
are not configured.
The set pvc command allows the configuration of a PVC (permanent virtual circuit) for an individual ADSL
port.
5.5.22 Set PVCs Command
Syntax:
192.168.1.1 adsl> set pvcs [
vci>]
where
= either “llc” or “vc”
= the VPI setting of the ADSL ports for use with a TX based network
= the VCI setting for the ADSL ports for use with a TX based network
= the VPI setting for the ADSL ports for use with Rx based networks
= the VCI setting for the ADSL ports for use with Rx based networks
The and settings will be equal to those of and if the rx settings
are not configured.
The set pvcs command allows you to configure a single PVC for all of the ADSL ports at once.
5.5.23 Show PVC Command
Syntax:
192.168.1.1 adsl> show pvc
where
= port number, from 1 to 8.
The show pvc command allows you to display the PVC parameters of an individual ADSL port.