ZyXEL Communications AES-100 - Manual (Page 26)

AES-100 User’s Guide
4-2 System Commands
192.168.1.1 adsl>
To get back to the top level prompt from a subsystem, use the home command.
The remainder of this user’s guide describes CI Commands that are helpful for configuring network
modules.
4.3.1 Help Facility
The system includes a help facility to provide you with online assistance.
• You can issue the help or ? command at any time. The system will display a list of available commands in
response.
• You can issue
help with a command name to get more details about it, for instance, the command
192.168.1.1> help version
yields
version - show system software version
The system responds with a description of the version command.
4.3.2 Saving Your Configuration
Always remember to save your configuration using the following syntax:
192.168.1.1> config save
This command saves all system configurations into nonvolatile memory. You must use this command to save any
configurations that you make, otherwise the AES-100 will return to its default settings when it is restarted.
Do not turn off your AES-100 while saving your configuration.
4.4 Commonly Used Commands
This section shows you commonly used commands.
4.4.1 Uptime Command
Syntax:
192.168.1.1> uptime
This command shows the elapsed time the system has been running since the last reboot.
4.4.2 Version Command
Syntax:
192.168.1.1> version
This command shows the system firmware version and date
4.4.3 Restart Command
Syntax: