ZyXEL Communications AES-100 - Manual (Page 39)

AES-100 User’s Guide
ADSL Configuration 5-7
5.5.10 List Port Command
Syntax:
192.168.1.1 adsl> list port
where
= port number, from 1 to 8
The list port command shows the configured maximum upstream/downstream rates, the mode (or standard),
and enable/disable state of an individual ADSL port.
5.5.11 List Ports Command
Syntax:
192.168.1.1 adsl> list ports
The list ports command shows the configured maximum rates, modes and states of all ADSL ports.
5.5.12 Set Profile Command
Syntax:
192.168.1.1 adsl> set profile [
]
=
where
= The name of the profile (up to 32 characters).
= The maximum ADSL upstream transmission rate.
= The maximum ADSL downstream transmission rate.
= The target ADSL upstream signal/noise margin (0..31db).
= The target ADSL downstream signal/noise margin (0..31db).
= The minimum acceptable ADSL upstream signal/noise margin (0..31db).
= The minimum acceptable ADSL downstream signal/noise margin (0..31db).
= The maximum acceptable ADSL upstream signal/noise margin (0..31db).
= The maximum acceptable ADSL downstream signal/noise margin (0..31db).
= The minimum ADSL upstream transmission rate in Kbps.
= The minimum ADSL downstream transmission rate in Kbps.
ATU-C ( atuc ) stands for ADSL Termination Unit-Central and refers to downstream transmission and ATU-R
( atur ) stands for ADSL Termination Unit-Remote and refers to upstream transmission.
The profile is a table that contains information on ADSL line configuration. Each entry in this table reflects a
parameter defined by a manager, which can be used to configure the ADSL line.
Note that the default value will be used for any of the above fields that are omitted.
The upstream rate must be less than or equal to the downstream rate.