ZyXEL Communications AES-100 - Manual (Page 27)

AES-100 User’s Guide
System Commands 4-3
192.168.1.1> restart
This command instructs the system to perform a warm start, that is, restarting the system without turning the power
off and on.
4.4.4 Passwd Command
Syntax:
192.168.1.1> passwd
This command changes the management password. The management password is used for authentication at console
or Telnet login. This command is only allowed for local console management sessions. The management password
must be from 1 to 8 characters long and any character is accepted. The factory default password is “1234”.
It is very important that you remember your password. If you forget it, refer to the Troubleshooting section
for help.
4.4.5 Config Print Command
Syntax:
192.168.1.1> config print
This command lists all current system configuration settings.
4.4.6 Exit Command
Syntax:
192.168.1.1> exit
This command terminates the console or telnet management session.
4.5 Sys Commands
4.5.1 Info Command
Syntax:
192.168.1.1 sys> info
This command displays system related information.
4.5.2 Set Name Command
Syntax:
192.168.1.1 sys> set name
This command allows you to set the name of your AES-100. The previous setting will be cleared if the command is
entered with the parameter omitted.
4.5.3 Set Contact Command
Syntax: