Yamaha DM2000 - Manual (Page 93)

Routing Input Channels
93
DM2000 Version 2—Owner’s Manual
You can also control the parameters from the channel strips on the control surface as
described below by using the User Assignable Layer of the Remote Layers. See page 269 for
information on the User Assignable Layer.
Encoders: The Encoders are not available.
[AUTO] buttons: These buttons are used to control the Fader Group Master On/Off and
the master level during Automix.
[SEL] buttons: These buttons move the cursor on the Input Fader Group Master page.
[SOLO] buttons: These buttons turn the Solo function of each Fader group on and off.
You can monitor all the channels in each Fader group.
Channel Strip Displays: The displays indicate the Group names (GrpA – GrpH). When
you operate the channel faders, the displays indicate the corresponding master level values.
Channel Faders: The channel faders enable you to set the master level for each Fader
group.
Routing Input Channels
Each Input Channel can be routed to the Bus Outs, Stereo Out, or its own Direct Out.
Using the SELECTED CHANNEL ROUTING Controls
1 Use the LAYER buttons to select the Input Channel Layers,
and use the [SEL] buttons to select the Input Channels.
2 Use the [1–8], [STEREO], and [DIRECT] buttons to route the
currently selected Input Channel.
[1–8]: These buttons route the currently selected Input Channel to the
Bus Outs.
[STEREO]: This button routes the currently selected Input Channel to
the Stereo Out.
DIRECT: This button routes the currently selected Input Channel to its Direct Out.
[FOLLOW PAN]: This determines whether the Input Channel’s Pan control setting is
applied to the Bus Outs. When off, the levels of the signals fed to the odd and even Bus Outs
is the same. When on, the levels of the signals fed to the odd and even Bus Outs follows the
Pan control.
In Surround mode, when this button is turned off, the surround pan setting does not affect
signals fed to the Bus Outs. You can enable the surround pan setting when the input source
is monaural, and patch the surround sources or surround effects directly to the Surround
Buses.
ROUTING
1 2
3 4
5 6
7 8
STEREO FOLLOW PAN DIRECT
DISPLAY