Yamaha DM2000 User Manual
Page 134
134
Chapter 12—Common Channel Functions
DM2000 Version 2—Owner’s Manual
EQ Edit Pages
EQ parameters can also be set on the EQ Edit page. If the Auto EQUALIZER Display pref-
erence is on, this page appears automatically when a control in the SELECTED CHANNEL
EQUALIZER section is operated. See “Auto EQUALIZER Display” on page 275.
1
Use the EQUALIZER [DISPLAY] button to select the EQ Edit page.
2
Use the LAYER buttons to select Layers, and use the [SEL] buttons to select
channels.
3
Use the cursor buttons to select the parameters, and use the Parameter
wheel and INC/DEC buttons to set them.
EQ ON: This turns the EQ on and off. The [ENTER] button can be used to turn this on
and off so long as any parameter other than TYPE is selected.
TYPE: This selects the type of EQ: TYPE I (the EQ type used on legacy Yamaha digital mix-
ing consoles) or TYPE II (a newly developed algorithm).
ATT: This can be used to attenuate signals pre-EQ. It’s the same Attenuator parameter that
appears on the Attenuator pages. See “Attenuating Signals” on page 130 for more informa-
tion.
CURVE: This displays the EQ curve of the currently selected Input Channel.
Level meters: These meters indicate the levels of the currently selected Input Channel
and its horizontal or vertical partner.
LOW, L-MID, H-MID, HIGH: These are the Q, Frequency (F), and Gain (G) parameters
for the four bands. The parameter (F or Q) you selected using the FREQUENCY/Q control
is highlighted.