Yamaha DM2000 User Manual
Page 192
192
Chapter 16—Scene Memories
DM2000 Version 2—Owner’s Manual
2
Use the cursor buttons, [SEL] buttons, or Parameter wheel to select the chan-
nel category, then use the [ENTER] button or the INC/DEC buttons to select
the copy source channel.
The number of the source channel is highlighted.
GROUP MASTER/OTHERS: You can also select Group Masters, internal Effects proces-
sors, a User Defined Remote layer, User Defined Plug-in, HA (AD8HR/AD824), or GEQ as
copy sources.
3
Use the cursor buttons or Parameter wheel to select the copy source param-
eter, then press the [ENTER] button.
4
Use the cursor buttons or Parameter wheel to select the destination chan-
nels, then press the [ENTER] button.
5
Use the SCENE MEMORY [DISPLAY] button to locate the Global Paste Des-
tination Scene page.
6
Use the Parameter wheel or INC/DEC buttons to select the destination
scene(s).
Scenes specified between FROM and TO (inclusive) become the paste destination. You can
paste up to 10 scenes at a time.
7
Use the cursor buttons to select the PASTE button, then use the [ENTER] but-
ton to paste the settings.
You cannot paste the settings to write-protected scenes.
UNDO: This button restores the settings used prior to the paste operation. However, if the
settings in the scene are changed after the paste operation (such as by saving, clearing, or
sorting the scene, loading scene data from SmartMedia, or receiving scene data via MIDI
Bulk Dump), the UNDO function is disabled.