ZyXEL Communications Prestige 2602H Series - Manual (Page 138)

Prestige 2602H/HW Series User’s Guide
138 Chapter 8 Introduction to VoIP
8.5 Voice Coding
A codec (coder/decoder) codes analog voice signals into digital signals and decodes the digital
signals back into voice signals. The Prestige supports the following codecs.
8.5.1 G.711
G.711 is a Pulse Code Modulation (PCM) waveform codec. G.711 provides very good sound
quality but requires 64kbps of bandwidth.
8.5.2 G.729
G.729 is an Analysis-by-Synthesis (AbS) hybrid waveform codec that uses a filter based on
information about how the human vocal tract produces sounds. G.729 provides good sound
quality and reduces the required bandwidth to 8kbps.
8.6 PSTN Call Setup Signaling
Dual-Tone MultiFrequency (DTMF) signaling uses pairs of frequencies (one lower frequency
and one higher frequency) to set up calls. It is also known as Touch Tone®. Each of the keys
on a DTMF telephone corresponds to a different pair of frequencies.
Pulse dialing sends a series of clicks to the local phone office in order to dial numbers.
1
8.7 MWI (Message Waiting Indication)
Enable Message Waiting Indication (MWI) enables your phone to give you a message–
waiting (beeping) dial tone when you have a voice message(s). Your voice service provider
must have a messaging system that sends message waiting status SIP packets as defined in
RFC 3842.
1. The Prestige does not support pulse dialing at the time of writing.