ZyXEL Communications Prestige 2602H Series - Manual (Page 104)

Prestige 2602H/HW Series User’s Guide
104 Chapter 5 Wireless LAN (P2602HW Models)
5.6.3 Authentication Required: WPA-PSK
Select Authentication Required in the Wireless Port Control field and WPA-PSK in the
Key Management Protocol field to display the next screen.
Figure 37 Wireless LAN: 802.1x/WPA:WPA-PSK
The following table describes the labels not previously discussed.
Table 24 Wireless LAN: 802.1x/WPA: WPA-PSK
LABEL DESCRIPTION
Key Management
Protocol
Choose WPA-PSK in this field.
Pre-Shared Key The encryption mechanisms used for WPA and WPA-PSK are the same. The
only difference between the two is that WPA-PSK uses a simple common
password, instead of user-specific credentials.
Type a pre-shared key from 8 to 63 printable characters (including spaces;
alphabetic characters are case-sensitive).
WPA Mixed Mode The Prestige can operate in WPA Mixed Mode, which supports both clients
running WPA and clients running dynamic WEP key exchange with 802.1x in the
same Wi-Fi network.
Select the check box to activate WPA mixed mode. Otherwise, clear the check
box and configure the Group Data Privacy field.
Group Data Privacy Group Data Privacy allows you to choose TKIP (recommended) or WEP for
broadcast and multicast ("group") traffic if the Key Management Protocol is
WPA and WPA Mixed Mode is disabled. WEP is used automatically if you have
enabled WPA Mixed Mode.
All unicast traffic is automatically encrypted by TKIP when WPA or WPA-PSK
Key Management Protocol is selected.
Authentication
Databases
This field is only visible when WPA Mixed Mode is enabled.