Figure 25 wireless lan – ZyXEL Communications P-2602HW(L) Series User Manual
Page 66

P-2602H(W)(L)-DxA Series User’s Guide
66
Chapter 3 Internet and Wireless Setup Wizard
The following table describes the labels in this screen.
3 Configure your wireless settings in this screen. Click Next.
Figure 25 Wireless LAN
The following table describes the labels in this screen.
Table 12 Wireless LAN Setup Wizard 1
LABEL
DESCRIPTION
Active
Select the check box to turn on the wireless LAN.
Enable OTIST
Select the check box to enable OTIST if you want to transfer your ZyXEL
Device’s SSID and WEP or WPA-PSK security settings to wireless clients that
support OTIST and are within transmission range.
You must also activate and start OTIST on the wireless client at the same time.
The process takes three minutes to complete.
Setup Key
Type an OTIST Setup Key of up to eight ASCII characters in length. Be sure to
use the same OTIST Setup Key on the ZyXEL Device and wireless clients.
Back
Click Back to display the previous screen.
Next
Click Next to proceed to the next screen.
Exit
Click Exit to close the wizard screen without saving.
Table 13 Wireless LAN Setup Wizard 2
LABEL
DESCRIPTION
Network
Name(SSID)
Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless
LAN.
If you change this field on the ZyXEL Device, make sure all wireless stations use the
same SSID in order to access the network.
Channel
Selection
The range of radio frequencies used by IEEE 802.11b/g wireless devices is called a
channel. Select a channel ID that is not already in use by a neighboring device.