5 configuring port forwarding, Figure 81 port forwarding, Table 49 port forwarding – ZyXEL Communications P-2602HW(L) Series User Manual
Page 147

P-2602H(W)(L)-DxA Series User’s Guide
Chapter 10 Network Address Translation (NAT) Screens
147
10.5 Configuring Port Forwarding
Note: If you do not assign a Default Server IP address, the ZyXEL Device discards
all packets received for ports that are not specified here or in the remote
management setup.
Click Network > NAT > Port Forwarding to open the following screen.
See
for port numbers commonly used for particular services.
Figure 81 Port Forwarding
The following table describes the fields in this screen.
Table 49 Port Forwarding
LABEL
DESCRIPTION
Default Server
Setup
Default Server
In addition to the servers for specified services, NAT supports a default server. A
default server receives packets from ports that are not specified in this screen. If
you do not assign a Default Server IP address, the ZyXEL Device discards all
packets received for ports that are not specified here or in the remote management
setup.
Port Forwarding
Service Name
Select a service from the drop-down list box.
Server IP Address Enter the IP address of the server for the specified service.
Add
Click this button to add a rule to the table below.
#
This is the rule index number (read-only).
Active
Click this check box to enable the rule.
Service Name
This is a service’s name.
Start Port
This is the first port number that identifies a service.
End Port
This is the last port number that identifies a service.
Server IP Address This is the server’s IP address.