ZyXEL Communications NBG-415N - Manual (Page 37)

ZyXEL NBG-415N User’s Guide
37 Chapter 3 Basic
Figure 19 Internet Connection Setup Wizard: Step 3 (L2TP)
The following table describes the related fields in this screen.
PPTP Server IP
Address (may be
same as gateway)
Type the IP address of the PPTP server.
User Name Type the user name given to you by your ISP. You can use alphanumeric and -
_@$./ characters, and it can be up to 31 characters long.
Password Type the password associated with the user name above. Use up to 64 ASCII
characters except the [, ] and ?. This field can be blank.
Verify Password Type your password again for confirmation.
Table 10 Internet Connection Setup Wizard: Step 3 (L2TP)
FIELD DESCRIPTION
Address Mode Select Dynamic IP If your ISP did not assign you a fixed IP address. This is the
default selection.
Select Static IP If your ISP assigned a fixed IP address. The set the following
fields.
L2TP IP Address This field is applicable if you select Static IP in the Address Mode field.
Enter the IP address that your ISP gave you. This should be a static, public IP
address.
L2TP Subnet
Mask
This field is applicable if you select Static IP in the Address Mode field.
Enter the subnet mask for the IP address.
L2TP Gateway IP
Address
This field is applicable if you select Static IP in the Address Mode field.
Enter the IP address of the router through which this WAN connection will send
traffic (the default gateway).
L2TP Server IP
Address (may be
same as gateway)
Type the IP address of the L2TP server.
User Name Type the user name given to you by your ISP. You can use alphanumeric and -
_@$./ characters, and it can be up to 31 characters long.
Table 9 Internet Connection Setup Wizard: Step 3 (PPTP)
FIELD DESCRIPTION