Wayne-Dalton TORQUEMASTER 6100 - Manual (Page 5)

5
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Required
POWER DRIll RaTChET WRENCh PlIERs/WIRE CuTTERs
PhIllIPs hEaD sCREWDRIVER PENCIl
1/8”, 3/16” DRIll bITs
flaT TIP sCREWDRIVER
7/16” sOCkET DRIVER
TaPE MEasuRE
NEEDlE NOsE PlIERs
7/16”, 1/2”, 9/16”, 5/8”
sOCkETs
3/8”, 7/16”, 1/2”, 9/16”
WRENChEs
safETy GlassEs
sTEP laDDER
PRE-INST
All
ATION
VICE GRIPs VICE ClaMPs
GlOVEs
(2) saW hORsEs haMMER
Removing An Existing Door
IMPORTANT: COuNTERbalaNCE sPRING TENsION MusT alWays bE RElEasED bEfORE aNy aTTEMPT Is MaDE TO sTaRT REMOVING
aN ExIsTING DOOR.
a POWERful sPRING RElEasING ITs ENERGy suDDENly CaN CausE sEVERE OR faTal INjuRy. TO aVOID INjuRy
haVE a TRaINED DOOR sysTEMs TEChNICIaN, usING PROPER TOOls aND INsTRuCTIONs, RElEasE ThE sPRING
TENsION.
for detailed information see supplemental instructions “Removing an Existing Door /Preparing the Opening”. These instructions are available
at no charge from Wayne-Dalton Corp., P.O. box 67, Mt. hope, Oh 44660, or at www.wayne-dalton.com.
WARNING