Center bracket bushing, Inst all ation, Drum wraps/ cable drums – Wayne-Dalton TORQUEMASTER 6100 User Manual

Page 21

Tools Needed:

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the

Find a Dealer section online at www.wayne-dalton.com

Center bracket bushing

NOTE: If you are installing the idrive

opener with your garage door, skip this
step and go to your idrive

Installation

Instructions and Owner’s Manual. after
completing steps 1-13 of your idrive

Installation Instructions and Owner’s
Manual, rear supports will need to be
fabricated/installed to support both
horizontal tracks, see step 28.

NOTE: If you are not installing the

idrive

opener on your garage door, you

must install the center bracket bushing
assembly. follow these instructions for
non-

idrive

operated garage doors.

being cam shaped the center bracket
bushing only fits one way.
slide the center bracket assembly
towards the center of the TorqueMaster

spring tube, from the right side as shown.

CENTER

bRaCkET

assEMbly

TORquEMasTER

sPRING TubE

TORquEMasTER

sPRING TubE

CENTER

bRaCkET

bushING

INST

All

ATION

IMPORTANT: RIGhT aND lEfT haND
Is alWays DETERMINED fROM INsIDE
ThE GaRaGE lOOkING OuT.

Drum wraps are identified as right hand and left
hand.

slide the left hand drum wrap over the left side
of the TorqueMaster

spring tube assembly

with the tabs facing left. Continue sliding the
left hand drum wrap towards the center of the
TorqueMaster

spring tube assembly.

Repeat for right hand side.

shake the TorqueMaster

Plus spring tube

assembly gently to extend the winding shafts out
about 5" on each side. for single spring
applications, there will be no left hand spring in
the TorqueMaster

Plus spring tube assembly.

lift the TorqueMaster

Plus spring tube assembly

and rest it on the top of the flagangles.

NOTE: Cable drums are marked right and left
hand. Cable drums and TorqueMaster

Plus

spring tube assembly are cam shaped to fit
together only one way.

Drum Wraps/ Cable Drums

WINDING shafT

5”

TORquEMasTER

sPRING TubE assEMbly

None

1-1/2 WRaPs

RIGhT DRuM

TORquEMasTER

Plus

sPRING TubE assEMbly

(CaM PEak sTRaIGhT uP)

COuNTERbalaNCE CablE

TORquEMasTER

sPRING TubE

assEMbly

Tabs

lEfT haND DRuM WRaP

lEfT haND

DRuM WRaP

RIGhT haND

DRuM WRaP

Tape Measure

step ladder