Wayne-Dalton TORQUEMASTER 6100 - Manual (Page 30)

Tools Needed:
30
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
PlaCE VICE ClaMPs
bElOW bOTTOM sECTION
ON bOTh VERTICal TRaCk
PaWl kNOb IN lOWER
POsITION
PaWl kNOb IN uPPER
POsITION
lOWER POSITION UPPER POSITION
TorqueMaster® Plus Reset
Instructions Continued...
PaWl
END bRaCkET
RaTChET
WITh 5/8”
sOCkET
3” ExTENsION
If the system is engaged, DO NOT attempt
to make the repairs. Instead, have a
trained door system technician make the
necessary repairs to cables, spring
assemblies and other hardware.
Double spring system: Visually inspect
the TorqueMaster ® Plus end brackets to
confirm that the system has engaged (see
illustration). Door will open, but will not
close. Door makes a distinct “clicking”
noise upon being opened. If the system is
engaged, carefully follow the reset
instructions below or refer to the reset tag
(attached to right hand end bracket) to
reset the TorqueMaster ® Plus system.
RESETTING AN ENGAGED
TORqUEMASTER ® PlUS DOUblE
SPRING SySTEMS ONly:
1. first, locate and visually inspect the
TorqueMaster ® Plus end brackets to
confirm that the system is engaged (see
illustration).
2. Disengage the opener (if installed) by
pulling or placing the emergency
disconnect in the manual operated
position.
3. With assistance, raise the door to the
fully open position.
4. Place vice clamps onto both vertical
tracks just below the bottom roller on
both sides.
5. Now is a good time to remove vehicles
or personal items from garage to provide
clear access to end brackets.
6. flip the ratchet pawl knob on both end
brackets to the upper position (see
illustration).
7. Raise door 2”-3” and then lower door.
Repeat this process until the system
resets (see disengaged system
illustrations).
IMPORTANT: bE PREPaRED TO suPPORT
ThE TOTal WEIGhT Of ThE DOOR.
8. Cautiously remove the vice clamps
from the vertical tracks. With assistance,
lower door.
ChECkING SPRINGS FOR TENSION:
9. starting on the right hand side, place a
ratchet wrench with 5/8” socket on the
TorqueMaster ® Plus winding shaft (see
illustration). Ensure ratchet is set so that it
will tighten counter clockwise on the right
hand side, and clockwise on the left hand
side. If tension is present, remove the
ratchet and check the left hand side. If
springs have tension, proceed to the
paragraph titled balaNCING DOOR; if no
spring tension is present, contact a
qualified door systems technician to
replace the spring(s).
IMPORTANT! TO aVOID POssIblE INjuRy,
haVE a TRaINED DOOR sysTEM
TEChNICIaN MakE aDjusTMENTs/
REPaIRs TO CablEs, sPRING
assEMblIEs aND OThER haRDWaRE.
�