Wayne-Dalton TORQUEMASTER 6100 User Manual

Page 15

Tools Needed:

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the

Find a Dealer section online at www.wayne-dalton.com

Stacking Sections

Power Drill

7/16” socket

Driver

(2) 1/4”-14 x 5/8”

sElf TaPPING sCREWs

END hINGEs (lEfT haND shOWN, RIGhT

hINGE syMMETRICally OPPOsITE)

INTERMEDIaTE hINGEs

(3) 1/4”-14 x 5/8” sElf

TaPPING sCREWs

NOTE: for door section identification see

page 4.

NOTE: Make sure hinges are flipped down,

when stacking another section on top.

NOTE: larger doors will use long shaft

rollers with double wide end hinges

Place rollers in hinge tubes of the second
section (lock section). With assistance, lift
second section and guide rollers into the
vertical tracks. keep patterns on front of
sections aligned, and fasten center hinges
first and end hinges last with 1/4”-14 x
5/8” self tapping screws. Repeat for other
section(s) except top section.

IMPORTANT: Push & hOlD ThE hINGE

lEaf aGaINsT sECTION WhIlE sECuRING
WITh 1/4”-14 x 5/8” sElf TaPPING
sCREWs. END hINGEs haVE (2) sCREWs
aND INTERMEDIaTE hINGEs haVE (3)
sCREWs; DOublE END hINGEs haVE (5)
sCREWs.

NOTE: lock(s) are required if door is not

installed with opener. Install lock at this
time (sold separately) see instructions in
OPTIONal INsTallaTION on page 32.

(5) 1/4”-14 x 5/8” sElf

TaPPING sCREWs

DOublE END hINGEs (lEfT haND shOWN,

RIGhT hINGE syMMETRICally OPPOsITE)

Top Roller Slides

To install the top roller slides, align
the slots in the top roller slide with the
second set of holes on the bottom of the
u-bar.

loosely, fasten using (2) 1/4” - 14 x 5/8”
self tapping screws. The bracket will be
tightened and adjusted in step 18. Insert
rollers into top roller slide. Repeat for
left side.