Wayne-Dalton TORQUEMASTER 6100 - Manual (Page 32)

Tools Needed:
32
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Side lock
Install the side lock on the second
section of the door. secure the lock
to the section with (4) 1/4”- 20 x
11/16” self drilling screws. square the
lock assembly with the door section
and align with the square hole in the
vertical track. The side lock should be
spaced approximately 1/8” from the
section edge.
IMPORTANT: sIDE lOCks MusT bE
REMOVED OR MaDE INOPERaTIVE IN
ThE uNlOCkED POsITION If aN
OPERaTOR Is INsTallED ON ThE
DOOR.
NOTE: after completing this step,
continue with step 13 on page 15.
�
(4) 1/4”- 20 x 11/16”
sElf DRIllING sCREWs
1/8”
Power Drill
7/16” socket
Driver
Pull Rope
DO NOT INsTall Pull ROPEs
ON DOORs WITh ElECTRIC
OPERaTORs. ChIlDREN May
bECOME ENTaNGlED IN ThE
ROPE CausING sEVERE OR
faTal INjuRy.
Measure and mark the jamb
approximately 48” to 50” (1220 to 1270
mm) from floor on the right or left side
of jamb. Drill 1/8” pilot hole for No. 6
screw eye. Tie the pull rope to the No.
6 screw eye and to the bottom bracket
as shown.
WARNING
�
Power Drill
1/8” Drill bit
NO. 6 sCEW EyE
Pull ROPE
bOTTOM bRaCkET
Pull ROPE