beautypg.com

Wayne-Dalton TORQUEMASTER 6100 User Manual

Page 13

background image

13

Tools Needed:

Tools Needed:

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the

Find a Dealer section online at www.wayne-dalton.com

Drums

Wa

rning

Wa

rning

Power Drill

7/16” socket

Driver

TORquEMasTER

®

DRuM

bOTTOM sECTION

MIlfORD PIN

ROllERs

ROllER slIDE

bOTTOM bRaCkET

bOTTOM

sECTION

asTRaGal

Roller Slides

starting with the bottom section, place

a roller slide on the top left side of the

u-bar and align with the first set of

holes (closest to the section) as shown.

attach the roller slide to the u-bar with

(2) 1/4”-14 x 5/8” self tapping screws.

Repeat for opposite side. Install roller

slides on the right and left side of each

u-bar, on all remaining sections with

the exception of the top section.
a viewing hole on the roller slide will

allow for correct positioning of roller

slide on u-bars. Place roller slides on

the sections as follows:
lock section (second section) use the

second set of holes.
Intermediate section (Third section) use

the third set of holes.
fasten all roller slides to the u-bar with

(2) 1/4”-14 x 5/8” self tapping screws.

None

ROllER slIDE

1/4”-14 x 5/8” sElf

TaPPING sCREWs

1

2

3

4

u-ba

R

8

9

1

2

3

4

VIEWING hOlE

WaRNING labEl

WaRNING labEl

IMPORTANT: RIGhT aND lEfT haND Is

alWays DETERMINED fROM INsIDE ThE

buIlDING lOOkING OuT.

NOTE: for door section identification see

page 4.

TorqueMaster

®

counterbalance drums

are marked right and left hand. uncoil

the counterbalance cables and make

sure you place the right hand cable loop

on the right hand milford pin and place

the left hand cable loop on the left hand

milford pin. Insert a roller into bottom

bracket of the bottom section and insert

another roller in the roller slide at the top

of the bottom section. Repeat for other

side.

NOTE: Verify astragal (bottom seal)

is aligned with door section. If there

is more than 1/2” excess astragal on

either side, trim astragal even with door

section.

INST

All

ATION