Wayne-Dalton TORQUEMASTER 6100 - Manual (Page 18)

Tools Needed:
18
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
NOTE: If you have fully adjustable
flagangles, skip this step and complete
step 17.
To install horizontal track, place the
curved end over the top roller. align
key slot of the horizontal track with the
quick install tab of the flagangle. Push
curved portion of horizontal track down
to lock in place.
DO NOT RaIsE DOOR uNTIl
hORIzONTal TRaCks aRE
sE CuRED aT REaR, as OuTlINED
IN sTEP 28, OR DOOR COulD
fall fROM OVERhEaD POsI-
TION CausING sEVERE OR faTal
INjuRy.
level the horizontal track assembly and
bolt the horizontal angle to the slot in
the flagangle using (1) 3/8” - 16 x 3/4”
truss head bolt and (1) 3/8” - 16 hex
nut. Repeat for other side. Remove the
nail that was temporarily holding the
top section in place, installed in step
15.
IMPORTANT: faIluRE TO REMOVE NaIl
bEfORE aTTEMPTING TO RaIsE DOOR
COulD CausE PERMaNENT DaMaGE
TO TOP sECTION.
NOTE: If an idrive ® opener will be
installed, position horizontal tracks
slightly above level.
NOTE: after completing this step,
continue with step 18.
kEy
slOT
quICk
INsTall
Tab
hORIzONTal
TRaCk
VERTICal
TRaCk
fla
Ga
NG
lE
16
WARNING
9/16” socket
Ratchet Wrench
9/16” Wrench
level
step ladder
kEy slOT
quICk
INsTall
Tab
hORIzONTal
TRaCk
VERTICal
TRaCk
fla
Ga
NG
lE
Attaching quick Install Flagangles
to horizontal Tracks
3/8” - 16 x 3/4”
TRuss hEaD bOlT
3/8” - 16 hEx NuT
hORIzONTal TRaCk
hORIzONTal aNGlE