Warning – Wayne-Dalton TORQUEMASTER 6100 User Manual

Page 24

Tools Needed:

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the

Find a Dealer section online at www.wayne-dalton.com

Place vice clamps onto both vertical
tracks just above the third roller. This is
to prevent the garage door from raising
while winding the counterbalance
springs.

faIluRE TO PlaCE VICE

ClaMPs ONTO VERTICal

TRaCks CaN allOW DOOR TO

RaIsE aND CausE sEVERE OR

faTal INjuRy

Securing Door

for Spring Winding

TRaCk

Vice Clamps

WARNING

PlaCE VICE

ClaMPs abOVE

3RD ROllER

Check to ensure the cable is aligned
and seated in the first and second
groove of the cable drum. snug the set
screw, and then tighten an additional
1-1/2 turns.

IMPORTANT: ENsuRE ThE CablE Is
alIGNED aND sEaTED IN ThE fIRsT
GROOVE Of ThE CablE DRuM PRIOR TO
WINDING sPRINGs.

Measure approximately 6” of cable and
cut off excess cable. Insert end of cable
in hole of cable drum.

NOTE: Illustrations show the right
TorqueMaster

Plus drum, left

TorqueMaster

Plus drum is

symmetrically opposite.

Cable Adjustment

Vice Grips

Pliers/Wire

Cutters

flat Tip

screwdriver

step ladder

6”

fIRsT aND
sECOND
GROOVE

sET sCREW

RIGhT haND
DRuM

CaM PEak

1-1/2 WRaP

CablE DRuM hOlE

VICE ClaMPs

aTTaChED TO

TRaCk