Wayne-Dalton TORQUEMASTER 6100 - Manual (Page 12)

Tools Needed:
12
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
7
Tape Measure
Pencil
Power Drill
1/16” Drill bit
lift handle Installation
NOTE: Reference illustrations for lift
handle positions on single and double
car garage doors.
Measure the width of the center stile
which will receive the lift handle(s).
Divide that measurement in half and
mark a vertical line on the center of the
stile.
If you are installing two lift handles on
the stile, you will need to measure from
the edge of the center stile to the center
line mark. Divide that measurement
in half and draw a second and third
vertical line parallel to the previously
made center line mark.
Measure the height of the panel. Divide
that measurement in half and mark a
horizontal line, intersecting the vertical
line(s) previously marked. Measure up
3-7/8” from the intersecting line(s) and
mark another horizontal line.
use the point(s) where the top
horizontal line intersects the vertical
line(s) to locate the top hole of the lift
handle(s).
using the lift handle as a template,
mark this location on the stile. keeping
the carriage handle aligned on the
vertical line, mark the lower carriage
handle hole on the stile.
Drill 1/16” pilot holes, then fasten both
lift handles using #10 x 5/8” pan head
self tapping screws.
If the door came with two sets of lift
handles repeat process.
lIfT haNDlE PlaCEMENT REfERENCE ON sINGlE WIDE DOORs
lIfT haNDlE PlaCEMENT REfERENCE ON DOublE WIDE DOORs
lOCk sECTION
CENTER sTIlE
lOCaTE ThE
CENTER
3-7/8”
lOCaTE ThE
CENTERs
lIfT haNDlEs
hORIzONTal
lINE
#10 x 5/8” PaN
hEaD sElf
TaPPING sCREWs
VERTICally
alIGNED
VERTICally alIGNED
sINGlE WIDE DOORs DOublE WIDE DOORs