Chapter 1 overview, What’s new with release 3.1 – USRobotics NETServer/8 User Manual
Page 9
Overview 1-1
Chapter 1
Overview
This chapter provides an overview of the Total Control
NETServer/8 and NETServer/16. It also contains information
on what’s new in version 3.1 of the NETServer firmware.
What’s New with Release 3.1?
Release 3.1 supports the following new features:
•
Classless InterDomain Routing and Host-based routing via
the Netmask Table.
•
IP address spoofing.
•
Support for RADIUS accounting servers, ANI/DNIS, and
ICMP message logging.
•
Support for a secondary and a tertiary name server.
•
Randomized use of Default/Alternate Hosts for load
balancing.
•
New Modem Port Features
Additional Software Enhancements
•
NetBIOS over IPX support
•
PAP enable/disable
•
Pre-allocated system netbufs increased from 1000 to 1400
•
Rezero network statistics and session statistics saved until
next call
•
Unidirectional Van Jacobson compression
•
Users set to Prompt may specify a TCP port with the host
name or IP address when using Telnet